I’ve just moved my z-wave installation over from Indigo and to a happily surprising extent, the transition has gone very well.

However, several different PIR sensors from different brands (homeseer, Ecolink, VisionPro) are detected as lights by HA, even if they have, in some cases, configuration options that are related to a PIR. HA assigns them a bulb icon, and the only control shows as a switch with the name “Basic.”

Is this a known bug, and is there any way to get HA to reassign the correct sensor type to these devices short of un-including and re-including them? Is that likely to get them working?

I’m also seeing a ZP3102 PIR sensor by Vision Security that’s showing only as a “basic” sensor.

Any advice? These sensors showed up fine in Indigo.

  • Claude Flammang@dju.social
    2·
    5 days ago

    @Mpeach45
    Click on „Basic“ then settings (the gear icon) and you should have a „display as“ setting.
    If z-wave integration does not allow that, you can always create a template sensor that converts it to binary sensor.
    Did anyone tell you that HA can be quite a rabbit hole where you can achieve virtually anything but not always easily.